1. Remote Notification
Jingle will be connected to WIFI network. When open Jingle APP on phone, message will be sent to your phone if visitor presses the bell. After receive the message on your phone, you can choose the video function to start a visual conversation.
2. Motion Detection
With PIR(pyroelectric infrared sensor), if someone passes your door, Jingle will take photo automatically and upload it to sever, your phone will receive a reminding message at the same time.
3. Real-time Monitoring
Monitor the condition outside the door through the smart phone App, acknowledge the surrounding environment forwardly, and can take and save photos locally.
4. Infrared Night Vision
Can detect the brightness of the surrounding environment automatically, and then the double optical filters can switch to night vision function.
5. Video Review
Visitor knock the door through the Jingle or someone pass by, can make video automatically, review the video on the smartphone, (not including TF card).
6. Long Time Stand by
Lower power consumption WIFI, micro-ampere level under standby mode. Use time is up to 6 months. (Based on 10 times per day , 10 seconds each time.)
7, easy to install
Two pieces 3.7V rechargeable lithium battery power supply, no wiring, 5V Micro USB interface charging, easy to disassemble and charge.
Image Processing Chip: FH8610
Image Sensor: 1/4 inch CMOS Sensor
Video: 800*600, H.264, Multi-Rate Video
Built-in Microphone, Built-in Speaker,
Built-in Voice Echo Cancellation Chip,
Built-in Audio Amplifier Circuit
0.8Lux/F1.4 (Color Mode),
0.3Lux/F1.4 (Black-and-White Mode)
Two 850 Infrared Lamp (Illuminate More Than 5 Meters),
Dual IR-CUT Filter, 850nm
WiFi 2.4GHz, IEEE802.11B\G\N
One-Button to Connect WIFI
Scan QR Code to Add Devices
Storage Extension: Support TF Card (Max to 32G)
Motion Detection: PIR Motion Detection with Adjustable Sensitivity
Battery: 2 Pieces Rechargeable 3.7V Lithium Battery
Li-ion 18650 battery for recharge, no cable need and easily assemble.
Working Current: 220-250mA
Standby Current: 400-800uA
Video Intercom Status:
When you press the doorbell Call Button, the Call Led Indicator will be on, along with a beep and DingDong sound. While the APP will receive a video intercom request and pop up the call answering interface. The device will capture the picture when the doorbell is pressed. If you want to push this request again, you need to wait for 8 seconds and then press the doorbell Call Button to continue pushing. When press the doorbell button during this waiting time, the speaker will be with DingDong sound, but the led indicator is not on. If you accept the call request, click the “Record” icon in the APP to begin video intercom. At this moment, the led indicator will keep on. If the network of doorbell is not good, the led indicator on doorbell will flash irregularly. If the terminal screen is locked, the video will be disconnected and need to re-enter.